Vertical Robotics Competition
  • Welcome to VRC!
  • Before We Get Started
    • Phase I Overview
    • Helpful Links
  • Primary Goal: Assembly and Configuration
    • VRC Drone Kit Contents
    • VRC Drone Assembly
      • Arms and Motors
      • Landing Gear, PDB, and Rails
      • ESCs, FC Power Module, and Receiver
      • Flight Controller Enclosure
      • Mounting the Flight Controller
      • Top Plate and Arms
      • FC and ESC Wiring
      • Propeller Adapters
    • RC Transmitter Setup
      • Basic Usage
      • Binding the RC Receiver
      • Setting the Output Mode
      • Setting Up Channels on the RC Transmitter
      • Setting Up Failsafe
    • FC Setup and Calibration w/ QGC
      • PX4 Firmware
      • Airframe
      • Sensors
      • Radio
      • Flight Modes and Kill Switch
      • Power
      • Safety
      • Motor Test
  • Sphero RVR
    • RVR Assembly
    • RVR Programming
  • Battery
    • Overview
    • Charging
    • Storage
  • Checkpoint #1: Flight Test
    • Before You Fly
    • Flight Test
    • After You Fly
  • SECONDARY GOAL: PCC
    • Laptop Setup
      • Setting Up Windows
      • Install Git Bash
      • Clone the VRC Repo
      • Install Anaconda
      • Install VS Code
      • Install SD Card Formatter
      • Install Balena Etcher
      • Install PuTTY
      • Install QGroundControl
    • Peripheral Control Computer (PCC)
      • Physical Assembly
      • Video Tutorial: Flash & Test PCC
      • Flash the PCC
      • Test the PCC
  • Overachiever Goal
    • Vehicle Management Computer (VMC) Setup
      • Preparing the Jetson
      • Flashing the SD Card
      • First Boot
  • 3D Printing Project
    • Project Overview
    • Sr. Design Project
    • Rotor Guards
  • Diving Deeper
    • Control Loops
    • Glossary
Powered by GitBook
On this page

Was this helpful?

  1. 3D Printing Project

Sr. Design Project

PreviousProject OverviewNextRotor Guards

Last updated 4 years ago

Was this helpful?

When the Bell VRC team decided to divide the 2021 competition into Phase 1 and Phase 2, it became clear that it would impact the seniors who graduate after Phase 1 and miss the excitement of Phase 2. The senior design project was created to highlight the seniors’ contributions in Phase 1 and give them an opportunity to shape and impact their team’s success in Phase 2.

The seniors on the team will be responsible for documenting and presenting the design process that was used in the 3D Printing Project. It is this documentation and presentation that will be judged as the Senior Design Project.

All the details, including the deliverables, judging, and prizes, can be found at .

REC