Vertical Robotics Competition
  • Welcome to VRC!
  • Before We Get Started
    • Phase I Overview
    • Helpful Links
  • Primary Goal: Assembly and Configuration
    • VRC Drone Kit Contents
    • VRC Drone Assembly
      • Arms and Motors
      • Landing Gear, PDB, and Rails
      • ESCs, FC Power Module, and Receiver
      • Flight Controller Enclosure
      • Mounting the Flight Controller
      • Top Plate and Arms
      • FC and ESC Wiring
      • Propeller Adapters
    • RC Transmitter Setup
      • Basic Usage
      • Binding the RC Receiver
      • Setting the Output Mode
      • Setting Up Channels on the RC Transmitter
      • Setting Up Failsafe
    • FC Setup and Calibration w/ QGC
      • PX4 Firmware
      • Airframe
      • Sensors
      • Radio
      • Flight Modes and Kill Switch
      • Power
      • Safety
      • Motor Test
  • Sphero RVR
    • RVR Assembly
    • RVR Programming
  • Battery
    • Overview
    • Charging
    • Storage
  • Checkpoint #1: Flight Test
    • Before You Fly
    • Flight Test
    • After You Fly
  • SECONDARY GOAL: PCC
    • Laptop Setup
      • Setting Up Windows
      • Install Git Bash
      • Clone the VRC Repo
      • Install Anaconda
      • Install VS Code
      • Install SD Card Formatter
      • Install Balena Etcher
      • Install PuTTY
      • Install QGroundControl
    • Peripheral Control Computer (PCC)
      • Physical Assembly
      • Video Tutorial: Flash & Test PCC
      • Flash the PCC
      • Test the PCC
  • Overachiever Goal
    • Vehicle Management Computer (VMC) Setup
      • Preparing the Jetson
      • Flashing the SD Card
      • First Boot
  • 3D Printing Project
    • Project Overview
    • Sr. Design Project
    • Rotor Guards
  • Diving Deeper
    • Control Loops
    • Glossary
Powered by GitBook
On this page

Was this helpful?

  1. Overachiever Goal
  2. Vehicle Management Computer (VMC) Setup

Preparing the Jetson

PreviousVehicle Management Computer (VMC) SetupNextFlashing the SD Card

Last updated 4 years ago

Was this helpful?

  • Unbox your Jetson

  • Unbox WiFi Adapter

  • Unscrew Jetson top

  • Push the tabs out

  • Pull out the Jetson Nano Module

  • Pull black screw

  • Slide in the WiFi card

  • Put in black screw

  • Slide module back into place

  • Replace screws

Now you're ready to flash the SD Card!