Vertical Robotics Competition
  • Welcome to VRC!
  • Before We Get Started
    • Phase I Overview
    • Helpful Links
  • Primary Goal: Assembly and Configuration
    • VRC Drone Kit Contents
    • VRC Drone Assembly
      • Arms and Motors
      • Landing Gear, PDB, and Rails
      • ESCs, FC Power Module, and Receiver
      • Flight Controller Enclosure
      • Mounting the Flight Controller
      • Top Plate and Arms
      • FC and ESC Wiring
      • Propeller Adapters
    • RC Transmitter Setup
      • Basic Usage
      • Binding the RC Receiver
      • Setting the Output Mode
      • Setting Up Channels on the RC Transmitter
      • Setting Up Failsafe
    • FC Setup and Calibration w/ QGC
      • PX4 Firmware
      • Airframe
      • Sensors
      • Radio
      • Flight Modes and Kill Switch
      • Power
      • Safety
      • Motor Test
  • Sphero RVR
    • RVR Assembly
    • RVR Programming
  • Battery
    • Overview
    • Charging
    • Storage
  • Checkpoint #1: Flight Test
    • Before You Fly
    • Flight Test
    • After You Fly
  • SECONDARY GOAL: PCC
    • Laptop Setup
      • Setting Up Windows
      • Install Git Bash
      • Clone the VRC Repo
      • Install Anaconda
      • Install VS Code
      • Install SD Card Formatter
      • Install Balena Etcher
      • Install PuTTY
      • Install QGroundControl
    • Peripheral Control Computer (PCC)
      • Physical Assembly
      • Video Tutorial: Flash & Test PCC
      • Flash the PCC
      • Test the PCC
  • Overachiever Goal
    • Vehicle Management Computer (VMC) Setup
      • Preparing the Jetson
      • Flashing the SD Card
      • First Boot
  • 3D Printing Project
    • Project Overview
    • Sr. Design Project
    • Rotor Guards
  • Diving Deeper
    • Control Loops
    • Glossary
Powered by GitBook
On this page

Was this helpful?

  1. Primary Goal: Assembly and Configuration
  2. FC Setup and Calibration w/ QGC

Radio

PreviousSensorsNextFlight Modes and Kill Switch

Last updated 4 years ago

Was this helpful?

In the section we configured the stick and switch channels. Now we will calibrate the endpoints of these channels so they can be saved to the FC. QGC makes this very easy to do and the process can be observed in the following video.

Now that your transmitter has been calibrated using the Radio screen in QGC we will move onto setting up our flight modes.

RC Transmitter Setup