Vertical Robotics Competition
  • Welcome to VRC!
  • Before We Get Started
    • Phase I Overview
    • Helpful Links
  • Primary Goal: Assembly and Configuration
    • VRC Drone Kit Contents
    • VRC Drone Assembly
      • Arms and Motors
      • Landing Gear, PDB, and Rails
      • ESCs, FC Power Module, and Receiver
      • Flight Controller Enclosure
      • Mounting the Flight Controller
      • Top Plate and Arms
      • FC and ESC Wiring
      • Propeller Adapters
    • RC Transmitter Setup
      • Basic Usage
      • Binding the RC Receiver
      • Setting the Output Mode
      • Setting Up Channels on the RC Transmitter
      • Setting Up Failsafe
    • FC Setup and Calibration w/ QGC
      • PX4 Firmware
      • Airframe
      • Sensors
      • Radio
      • Flight Modes and Kill Switch
      • Power
      • Safety
      • Motor Test
  • Sphero RVR
    • RVR Assembly
    • RVR Programming
  • Battery
    • Overview
    • Charging
    • Storage
  • Checkpoint #1: Flight Test
    • Before You Fly
    • Flight Test
    • After You Fly
  • SECONDARY GOAL: PCC
    • Laptop Setup
      • Setting Up Windows
      • Install Git Bash
      • Clone the VRC Repo
      • Install Anaconda
      • Install VS Code
      • Install SD Card Formatter
      • Install Balena Etcher
      • Install PuTTY
      • Install QGroundControl
    • Peripheral Control Computer (PCC)
      • Physical Assembly
      • Video Tutorial: Flash & Test PCC
      • Flash the PCC
      • Test the PCC
  • Overachiever Goal
    • Vehicle Management Computer (VMC) Setup
      • Preparing the Jetson
      • Flashing the SD Card
      • First Boot
  • 3D Printing Project
    • Project Overview
    • Sr. Design Project
    • Rotor Guards
  • Diving Deeper
    • Control Loops
    • Glossary
Powered by GitBook
On this page

Was this helpful?

  1. SECONDARY GOAL: PCC
  2. Laptop Setup

Install Balena Etcher

PreviousInstall SD Card FormatterNextInstall PuTTY

Last updated 4 years ago

Was this helpful?

Balena Etcher is an application that will allow us to write the operating system of the Vehicle Management Computer onto an SD Card.

You can find the download links .

Run the downloaded installer with the default options.

here