Vertical Robotics Competition Phase II
  • Welcome to Phase II!
  • Pre-requisites
    • Introduction
    • 3D Printing
    • Helpful Links
  • Phase II Drone Modifications
    • VMC and PCC Power
    • Landing Gear Upgrade
    • FC <-> VMC Telemetry Cable
    • VMC Mounting
    • WiFi Antenna Mounting
    • CSI Camera Mounting
    • T-265 Camera Mounting
    • PCC Mounting
    • FPV Projection Camera
    • Assembly Review
  • CHECKPOINT: FLIGHT TEST
    • Stabilized Flight Test
  • Phase II Software
    • Flight Controller Firmware
    • Flight Controller Parameters
    • VMC Software
    • Connecting QGC
    • GUI
  • Checkpoint: Flight Test
    • Position Flight Test
  • Coding Challenges
    • How Do Coding Challenges Work?
    • Sandbox
    • Autonomous Path Discovery
    • Autonomous Supply Drop
  • Diving Deeper
    • Glossary
Powered by GitBook
On this page

Was this helpful?

  1. Pre-requisites

3D Printing

PreviousIntroductionNextHelpful Links

Last updated 3 years ago

Was this helpful?

Please make sure to 3D print the following parts before beginning your VRC Phase II modifications. These are necessary to complete Phase II and prepare for competition day.

  • (x4)

    • Estimated print time: 1 hour 20 minutes per leg

  • (x2)

    • Estimated print time: 52 minutes per block

    • Estimated print time: 2 hours 10 minutes

  • (x2)

    • Estimated print time: 1 hour 15 minutes per print

    • The additional print will be used for mounting your PCC

    • Estimated print time: 1 hour 30 minutes

    • Estimated print time: 2 hours 30 minutes per motor

Phase II landing gear
VMC mounting blocks
VMC mounting case
VMC Wi-Fi antenna mount
T-265 mount
Rotor guards (x4)